SpecificationsWaste Water Evaporation Water Treatment Water Mister System

Evaporator Water Atomizer Manifold

Slimline Manufacturing Ltd offers two different types of nozzles in the same manifold layout. Each type of nozzle has pros and cons and the type of solution being pumped will likely be the determining factor in making a choice for your project.

The Teflon spiral nozzle: Option # 1010


Advantages:
  • Smallest water droplet – average 65 microns after air shear effect.
  • Less likely to clog due to design.
  • Less likely to scale in many solutions due to Teflon.
  • One piece, ease of replacement.

Disadvantages:
  • Cost – this is an industrial product and has limited volumes

The Stainless Steel disc and core hollow cone nozzle system: option # 1020


Advantages:
  • Cost – we can source this product through agricultural sources and because of the high volume are inexpensive in comparison to spiral industrial nozzles.

Disadvantages:
  • Multiple pieces, very easy to confuse when replacing. Each nozzle consists of a disc and core, which fits inside a nozzle body and has a cap to hold it together. If incorrectly reinstalled efficiency is effected.

  • In scaling type solutions, stainless steel is more likely to scale then Teflon.

Please note the output on these two nozzles are identical, the initial cost on a unit is only a difference of $100.00 so the deciding factor in choosing which option is best for your solution, is the water quality and catch basin size.

The output for either nozzle is 66 gallons per minute at 100 psi, 94 gallons per minute at 200 psi. We can provide large nozzles that increase volume pumped aloft, however it is our opinion that this volume results in the most efficient evaporation. We are available for discussion and explanation on this point, at the factory during office hours.