Specifications
Waste Water Evaporation Water Treatment Water Mister System
Evaporator Motor Mount and Coupling
The motor utilized is a custom-built super hostile duty 40 horsepower electric motor, available in 230/460 volt or 575 volt models and naturally is CSA and UL approved.
The unit is custom designed with dual VBX inpro seals ™ to make this unit as close to water tight as can be obtained on the market and is custom built for Slimline Manufacturing Ltd by US MOTORS. See section on Evaporator Motors for information.
The motor mount base is designed with push rods for alignment.
Each unit has 8 separate push bolts, 4 for the actual motor and 4 for the turbine housing. This is to ensure that our alignment sequence of the motor and turbine are easily achievable during and after manufacture.
The bearing mounting area in the turbine is machined to insure alignment during manufacture and maintenance.
The coupling manufacturer states the maximum parallel misalignment is 0.015 inches, angular misalignment is 0.025inches. Slimline Manufacturing Ltd specs are tighter at parallel misalignment of .007” an angular misalignment of .010”. To ensure these specifications are met, each machine is quality inspected and the actual misalignments are recorded for each unit by serial number.
To ensure the unit is ready to go upon delivery, each unit is PDI at the factory, that is grease lines have been purged and bearings are greased correctly. Then each unit is run to full rpm and vibration analysis is done and recorded, before shipping.